Installing Outdoor Porch Lights

Outdoor porch lights are a nice addition to any home. They enhance the beauty of the home as well as add the benefit of extra security. Installing porch lights where there never have been any requires some knowledge of working with electricity. You will first need to find where the junction box is for the porch lights. Once you have located the junction box it is just a matter of wiring a new box and installing the porch light.

House Lighting For Outdoor Design

House Lighting For Outdoor Design

You don’t need any professionals’ help to do this outdoor porch lights installation project, what you should do is following all these steps correctly and you’ll get your porch lights well-installed. To begin the project, you should prepare all these materials as follows;

  • Pencil
  • Junction box
  • 3/4-inch screws
  • Wall anchors
  • Drill
  • Screwdriver
  • Tape measure
  • UF outdoor electrical cable (enough to reach the old junction box and the new one)
  • Wire strippers
  • Wire nuts
  • Porch light kit

Lighting Porch Ideas For Outdoor

Lighting Porch Ideas For Outdoor

After you’ve got all the materials, you may start your job by marking the area where you want to install the porch light. It is a good idea to locate the light as close to the old junction box as possible. This will reduce the amount of wire you need to run.

Don’t forget to disconnect the power to the old junction box by turning off the circuit breaker. It is a good idea to shut off the main power if you are unsure of which breaker operates the junction box.

Modern Outdoor Porch Lighting

Modern Outdoor Porch Lighting

After that, attach the new junction box at the location you marked for the light fixture. If installing in wood you can use 3/4-inch wood screws. If the installation is on brick you will need to use expansion anchors with screws. When using expansion anchors, drill holes to the size of the anchor into the wall using a drill. Then gently tap the anchor in with the handle of a screwdriver.

Then, you should measure the distance between the old junction box and the new one using a tape measure. Cut a piece of UF electrical cable to your measurement, plus six inches. This will give you plenty of wire.

Outdoor Lighting Fixture Idea

Outdoor Lighting Fixture Idea

Insert the cable into each of the junction boxes. Strip about 1/2-inch of insulation from the cable at the old junction box using wire strippers. Connect the wires to the junction box by connecting the ground wire first, then white, and then black. Connect them to the old junction box wires using plastic wire nuts.

Next step; attach the porch light mounting plate to the new junction box using the attaching screws provided in the kit. Pull the wires through the mounting plate and connect them to the light fixture using plastic wire nuts. Push the wires back into the junction box while lining up the fixture on the mounting plate.

Unique Outdoor Porch Lights

Unique Outdoor Porch Lights

Remember to secure the fixture to the mounting plate with the provided hardware. Install a light bulb and attach the decorative light cover according to the manufacturer’s instructions. At last, turn the power on and test your light.

Now you’ve got beautiful outdoor porch lights enlighten and beautify your outdoor. Get a wonderful moment there!

garden lighting ideas, porch lights, unique outdoor lighting, outdoor home bar designs, porch lighting, photos of unusual garden lighting, unique landscape lighting, porch lighting ideas, indian garden design ideas, outdoor lights, unique outdoor lights, outdoor patio lights, decorating outside porch for fall, backyard lighting ideas, unique lights