How To Make Water Fountain Flower Pot?
One of the simplest water features you can make is a fountain in a container, like this one. You don’t need to spend much money to buy the new one, use the existing pot that you have and follow these steps below on how to make water fountain flower pot.
To get a nice water fountain, you can use any large pot. Terra-cotta is particularly handsome. If the container does not have a drainage hole in the bottom, drill one (using a masonry bit) or drape the pump’s electrical cord over the rim. Disguise the cord by guiding a few stems of one of the surrounding plants along the rim. Set the freestanding fountain in a garden bed or border that has an electrical outlet nearby; using an extension cord is not recommended. If you think you will have a problem with mosquitoes, add a few small goldfish, which will eat the larvae. The number of fish you can use, probably not more than two or three, will depend on the diameter and depth of the container.
To starts the process on how to make water fountain flower pot, you need to prepare all these items; container, 24 inches across or larger, pump and fountain, premixed quick-dry cement, liquid water sealant, bricks and outlet with ground fault circuit interrupter.
Installing A Pump Inside The Pot To Make A Water Fountain
Now, it’s time to do the project. You can do all these steps only in one day. First, you need to set a submersible pump in the bottom of the container. Using a pot that is at least 24 inches in diameter makes a splash and requires less water refilling than a smaller pot. Pull the pump electrical cord through the drainage hole of the pot.
Repurposing Old Pots To Be A Water Fountain
Pull out enough cord to be able to connect to the outlet, but don’t plug it in, and leave sufficient slack to raise the pump in the pot. Close the drainage hole with premixed, quick-drying cement. Let the cement dry thoroughly; follow directions on the package.
Collection Of Flower Pot Water Fountain Ideas
Seal the inside of the pot, whether it’s terra-cotta, wood, or some other porous material, with a liquid water sealant that is labeled for use on wood. Let the sealant dry completely.
Elevate the pump in the center of the container. Place it on bricks to bring it a few inches below where the water’s surface will be. Fill the pot with water and connect the pump to the GFCI outlet. Be sure the water level does not dip below the pump.
A Simple Water Fountain From Old School Pots
With just little creativity and aid of a small water pump and some tubing, you can make water fountain flower pot that adds visual and aural interest to any outdoor space.